OnRobot
Dual Quick Changer

  • Dual gripper speeds cycle time and can improve productivity by 50% or more.
  • The new Dual Quick Changer enables you to use our end-of-arm tools together in a single cycle. With this innovative solution you can use two RG2 grippers or an RG6 gripper with a VG10 – it’s entirely up to you. Quickly and seamlessly switch between OnRobot tools to maximize the utilization of your robots with the Dual Quick Changer.
  • The Dual Quick Changer has built-in electric feed-through for OnRobot tools. You can connect various tools. You can even use a Quick Changer Tool Side if you wish to use a non-OnRobot tool as well.

For software packages equal to or higher than SW 1.72, please find them accompanied with documents in OnRobot’s TM ROBOT support Page.

Beschreibung

Technical data Min Typical Max
Permissible force* [N] 400*
Permissible torque* [Nm] 50*
Rated payload* [kg] [lbs] – – – – 20*44*
Repeatability [mm] ±0.02
IP Classification 64
Operating life (Tool change) [cycles] 5.000
Operating life (Robot operation) [M cycles] 10